Hello again,
I have now found the problem. I had forgot to set up outputs for enable. I have used Mach 3 before, but never the elable signal.
You learn somthing new every day.
Now all 4 axis is moving, and the puls/per seems to be good.
Best reagards
Krister
Search found 3 matches
- Sat May 12, 2012 1:29 pm
- Forum: Troubleshooting
- Topic: TB6560 will not run
- Replies: 4
- Views: 7325
- Wed May 09, 2012 12:56 pm
- Forum: Troubleshooting
- Topic: TB6560 will not run
- Replies: 4
- Views: 7325
Re: TB6560 will not run
Hello again, When I push the red button on the screen, the alarm goes off. But the motors still have no power. If I disconnect the power to the TB6560, (and turn it back on) it is still the same. The A-axis (extruder) is working, if I jogg it. And the DRO in mach3 is moving, when I jogg, but the ...
- Mon May 07, 2012 1:38 pm
- Forum: Troubleshooting
- Topic: TB6560 will not run
- Replies: 4
- Views: 7325
TB6560 will not run
Hello, I have problem to get TB6560 to run. If I turn on power without parrallell cable connected, two red leds turn on. And no power to any motors. I then connect (power off) the parallell cable. When I power up 5 red leds turn on, and the motors have power. When I start Mach 3 the power to the ...