Welcome to the SeeMeCNC Community

Ok thanks, I'll move on to .92 then. I'll search here for some pointers on the configuration

Anyone know if there's anything inherently incompatible with .92 firmware and the MaxV1? I'm planning on doing some dev work on the firmware to add more than 2 "screens" to the lcd among some other minor changes and I'm just wondering if I should start with .92 or stick with .91. If .92 is fine ...

I've been getting decent prints for some time now with Repetier and my Rostock Max with E3dV5 hotend in linux and slicing using Slic3r. A while ago I thought I would give Cura a try and I wasn't too impressed, all of the prints came out a little bit sloppier than those from Slic3r. One of my main ...

I'm in the process of re-calibrating my Rostock Max V1. I'm using the .91 FW which has a git head of: commit aaf31d00081d79f967a133050d16001e4d952113 Author: John Oly <[email protected]> Date: Wed Jul 9 09:09:16 2014 -0400 updated motor current settings updated motor current notes for kysan motors I ...

Wondering if anyone has any tips or insight for my PID tuning troubles, I have referenced http://forum.seemecnc.com/viewtopic.php?f=37&t=4084&p=30587&hilit=autotune+failed#p30587 and I'm using those PID settings as a guide. [P,I,D as 40, .55 and 35] I started with EXT0_PID_INTEGRAL_DRIVE_MAX set to ...

Thanks, that page is very helpful!

I changed mine to pin 6 because my fan is plugged in to "Fan1" on the rambo. What does pin 7 actually correspond to on the RAMBO?

I just finished installing my new E3D hotend and I did the final torque adjustment and now I'm ready to run the PID autotuning process. My question is, during the process should I have the barrel cooling fan on? If so, how do I enable the fan from repetier? The fan control does not control it as my ...

I just sent an email to seemecnc today about my board not connecting. The description from the blog post sounds exactly like my situation so I guess I will start disassembling my board.

Thanks for the info.