both items brand new.
probe $25 including shipping.
713maker kit $50 including shipping
Search found 123 matches
- Fri Dec 15, 2017 1:48 pm
- Forum: Members Marketplace
- Topic: 713 maker hotend effector and hotend accelerometer probe
- Replies: 1
- Views: 1579
My LCD has the blue PCB and I made the same mistake. The LCD end is keyed, and I followed the silkscreen on the adapter board end. With the blue LCD board, the LCD didn't even illuminate. Once I flipped the cable orientation (opposite of the silkscreen) on the adapter end, my LCD worked fine. Mine ...
You've got something weird going on for sure. I just looked at mine and I've got the cabling connected to the interface board with the red wire on the left. Is that what you've got? Note that the "stability warning" is just a generic compiler message and doesn't apply to Repetier Firmware...
presently, lcd is displaying the two lines as if it has not been flashed. but it has. the pc can control the machine. is there a way to make sure the lcd is configured in the arduino? I do not see any reference to it in configuration.h. do not think I have a hardware problem. after it uploads it say...
sorry for confusion, blue was in kit, I had a red one lying around. the blue one has a black screen when plugged in, the red one has a lit up blank blue screengeneb wrote:I'd contact support Kevin. I'm surprised there's a red PCB LCD in there - they've been shipping the blue ones for quite some time.
yes.I reversed connectors, tried new cables and another lcd. it has a red board ,not blue like in the kit. flashed software twice.Eaglezsoar wrote:The first thing that I would do is to reverse the LCD connectors, sometimes it is hard to get them right even though the board has key marks.
uploaded software to Rambo, I can heat the bed,hotend and move axis from pc. The lcd beeps once, then constant click. screen is lit, but no words. the cable farthest from sd card slot goes to pins on little board next to word Rambo. little key on cable is synced with key symbol on little board on bo...
- Wed Sep 21, 2016 4:48 pm
- Forum: RostockMAX v3
- Topic: Limit Switches not engaging
- Replies: 16
- Views: 3920
yes, I put mine in, and saw that they were squashed down and jerked them off. the next day, I saw your manual revision! also make sure to remove the silver switch arms. THIS. A million times, THIS. I wasn't aware of that until AFTER my build was nearly done. I was highly annoyed when I found out I h...
- Thu Aug 27, 2015 10:03 pm
- Forum: The Lounge
- Topic: Borrow printer in San Antonio/Austin for prosthetic conf?
- Replies: 6
- Views: 2183
If you were in SC, you could borrow mine! It is so much fun to show it off at events. We will be at makerfaire in charlotte in October exhibiting