Search found 5 matches

by bsdtgr
Mon Jun 30, 2014 8:14 pm
Forum: Computer Hardware
Topic: Can't figure out how to load printer info into arduino
Replies: 0
Views: 1558

Can't figure out how to load printer info into arduino

I have arduino downloaded and my printer hooked up to my comp. I can't figure out how to open the files so I can make changes for my new print head.
by bsdtgr
Sat Mar 29, 2014 3:46 pm
Forum: Troubleshooting
Topic: New Bridge filament
Replies: 4
Views: 1220

Re: New Bridge filament

There was a little warp, but did not warp until after if pull it off the bed. I bent it back right away, and it sits nice and flat now. Currently using the standard hot-end, but I plan to upgrade to a higher grade to hold a better heat. The hot end that came with my Orion has a max temp of 245, and ...
by bsdtgr
Sat Mar 22, 2014 10:17 pm
Forum: Troubleshooting
Topic: New Bridge filament
Replies: 4
Views: 1220

Re: New Bridge filament

I increased the temp to 243, reduced layer height to .2mm, and slowed the speeds to 13mm/s. The piece is now unbreakable.
by bsdtgr
Mon Mar 17, 2014 11:15 am
Forum: Troubleshooting
Topic: New Bridge filament
Replies: 4
Views: 1220

New Bridge filament

Recently I purchased the new Bridge filament. I ran a test piece and I am able to easily peel my layers apart. Was hoping someone could help fix the problem. I used Aqua-Net for glue, and it stuck real good. The settings I used were: temp-235 bed-60 extrusion multiplier-1.02 layer height-.3 infill-....
by bsdtgr
Mon Mar 17, 2014 10:47 am
Forum: FAIL HAPPENS ! ! !
Topic: Layer separating on big ABS prints
Replies: 13
Views: 9281

Re: Layer separating on big ABS prints

I have found with my larger prints, when a strong breeze hits them it will cause a split in my layers. I have also seen a lot of people online using filament dusters to clean the filament as it is being used. As for the bubbling at 210, my guess would be moisture in your filament. If you store filam...

Go to advanced search