Search found 5 matches
- Mon Jun 30, 2014 8:14 pm
- Forum: Computer Hardware
- Topic: Can't figure out how to load printer info into arduino
- Replies: 0
- Views: 3600
Can't figure out how to load printer info into arduino
I have arduino downloaded and my printer hooked up to my comp. I can't figure out how to open the files so I can make changes for my new print head.
- Sat Mar 29, 2014 3:46 pm
- Forum: Troubleshooting
- Topic: New Bridge filament
- Replies: 4
- Views: 3475
Re: New Bridge filament
There was a little warp, but did not warp until after if pull it off the bed. I bent it back right away, and it sits nice and flat now. Currently using the standard hot-end, but I plan to upgrade to a higher grade to hold a better heat. The hot end that came with my Orion has a max temp of 245, and ...
- Sat Mar 22, 2014 10:17 pm
- Forum: Troubleshooting
- Topic: New Bridge filament
- Replies: 4
- Views: 3475
Re: New Bridge filament
I increased the temp to 243, reduced layer height to .2mm, and slowed the speeds to 13mm/s. The piece is now unbreakable.
- Mon Mar 17, 2014 11:15 am
- Forum: Troubleshooting
- Topic: New Bridge filament
- Replies: 4
- Views: 3475
New Bridge filament
Recently I purchased the new Bridge filament. I ran a test piece and I am able to easily peel my layers apart. Was hoping someone could help fix the problem. I used Aqua-Net for glue, and it stuck real good. The settings I used were: temp-235 bed-60 extrusion multiplier-1.02 layer height-.3 infill-....
- Mon Mar 17, 2014 10:47 am
- Forum: FAIL HAPPENS ! ! !
- Topic: Layer separating on big ABS prints
- Replies: 13
- Views: 14900
Re: Layer separating on big ABS prints
I have found with my larger prints, when a strong breeze hits them it will cause a split in my layers. I have also seen a lot of people online using filament dusters to clean the filament as it is being used. As for the bubbling at 210, my guess would be moisture in your filament. If you store filam...