Search found 4 matches
- Fri Jan 02, 2015 4:32 pm
- Forum: Rostock MAX v2
- Topic: Cold Hot End
- Replies: 4
- Views: 4333
Re: Cold Hot End
I've got similar issue. Seems that are heating resistors are dead. Could anyone suggest which resistor could replace them? (I mean brand and parameters for new resistors) Also if anyone got same issue: any guess why it might happen?In my case I was doing calibration using this algorithm http://forum ...
- Tue Mar 25, 2014 4:24 pm
- Forum: Rostock MAX
- Topic: Firmware reset problem
- Replies: 3
- Views: 4321
Re: Firmware reset problem
Thank you for hint, but how I can upload modified code? When I turn on the printer it moves down and doesn't stop when touch platform. I have no time for sending code to the controller board.
- Tue Mar 25, 2014 1:50 pm
- Forum: Rostock MAX
- Topic: Firmware reset problem
- Replies: 3
- Views: 4321
Firmware reset problem
Hi, I've download Repetier-091-ROSTOCKMAX and used this video instruction [youtube]http://www.youtube.com/watch?v=A4yMV18oMbw[/youtube] to set configuration options. After compilation and uploading to board printer moves extruder down until it bed and keep doing it. If I move it to top position and ...
- Tue Mar 25, 2014 1:30 pm
- Forum: New Member introduction
- Topic: Hello from Sain-Petersburg, Russia
- Replies: 1
- Views: 1816
Hello from Sain-Petersburg, Russia
I've got Rostock Max and just want to say hi to community. Is there anybody on forum from Saint P. too?