Welcome to the SeeMeCNC Community

Thanks. Is that file located in the Repetier host or where?

Does anyone know how to disable the bed sensor test on boot up. I assume it would be in the firmware EPROM setting but I'm not seeing it. I have a thermistor issue and I would like to run without the heated bed until I get it fixed but it errors out and goes into dry run mode because of the heat bed ...

Thanks you guys. I'm somewhat embarrassed that I didn't see the fuses. I kept glancing over them thinking they were chip capacitors. Anyway I found them online and ordered some. Once again thanks for your help.

Found the fuses and it is F2. Are these available at Radio Shack?

Thanks. Where are the three fuses located? I see only the big 15 amp one.

My Max V2 has been nothing but a pain. After the thermistor popping out of the hot end and me melting and ruining two hot end assemblies now while waiting for it to get up to temp (225) it reached the temp and then gave me an error saying the sensor failed. About two minutes later the display went ...