Thanks for the replies.
I swapped the red and blue wire as advised. My extruder now move in the correct direction. Thank you.
I see as the software is compiled before uploading to the Arduino you can not retrieve the settings.
Thanks again, Lance.
Search found 5 matches
- Thu Sep 13, 2012 5:30 am
- Forum: Troubleshooting
- Topic: Extruder works in reverse
- Replies: 4
- Views: 4587
- Wed Sep 12, 2012 6:41 am
- Forum: Troubleshooting
- Topic: Extruder works in reverse
- Replies: 4
- Views: 4587
Extruder works in reverse
Hi, I have finished (at last) building my H1. I have RAMPS 1.4 with the standard sprinter firmware and am using Pronterface to drive the printer. I have not overwritten the original firmware yet. The XYZ axis all seem to work, but the extruder works in reverse. I can see an option in the configurati...
- Tue Jul 03, 2012 8:29 am
- Forum: Rostock MAX Official Docs
- Topic: "H-1 Electronics Manual"
- Replies: 15
- Views: 30473
Re: "H-1 Electronics Manual"
Thanks I found the wiring diagram shortly after asking the question. I should have asked my wife to look before posting!
I have not got as far as thinking about firmware yet. Thanks for the heads up.
Lance.
I have not got as far as thinking about firmware yet. Thanks for the heads up.
Lance.
- Sun Jul 01, 2012 3:44 am
- Forum: Rostock MAX Official Docs
- Topic: "H-1 Electronics Manual"
- Replies: 15
- Views: 30473
Re: "H-1 Electronics Manual"
Hi, I just received my H1 and RAMPS1.4 kit. Is there a wiring diagram or instructions for this version?
Sorry, for the dumb question, but I have not been able to find much data yet.
Thanks in advance, Lance.
Sorry, for the dumb question, but I have not been able to find much data yet.
Thanks in advance, Lance.
- Thu Jun 28, 2012 6:57 am
- Forum: New Member introduction
- Topic: Printer arrived downunder
- Replies: 2
- Views: 2753
Printer arrived downunder
Hi all, I have just received my kit and am looking forward to starting the build. Thanks to all who have posted useful tips and solutions. Hopefully this will prevent a few frustrations. I am near Adelaide in South Australia. Any other printers in OZ? No doubt you will be getting questions from me s...