Awesome. I did read through that post as well, just wanted to make sure I didn't miss somewhere that the copper spray gasket did end up working out.
When you sand the PEI surface its only by hand and not with say an electric DA?
Search found 2 matches
- Sat Feb 14, 2015 10:29 pm
- Forum: General Tips 'N Tricks
- Topic: PEI print bed surface experiments
- Replies: 974
- Views: 1127515
- Sat Feb 14, 2015 9:25 pm
- Forum: General Tips 'N Tricks
- Topic: PEI print bed surface experiments
- Replies: 974
- Views: 1127515
Re: PEI print bed surface experiments
So, I stumbled upon this thread after recently getting my solidoodle press and researching a better surface then glass for abs printing. I read through as much as I could but i m not going to lie I didn't read it all. I did read somewhere that you mentioned you were going to try to use permatex ...