Welcome to the SeeMeCNC Community

Tried disconnecting it and turning it on, the local controls all seemed to be behaving fine. I could home all the axes with no issue. I proceeded to plug it into my computer and tested each of the limit switches via the M119 command and didnt find any issues there either. I held down each one and it ...

Went back for round two of troubleshooting based on your guys' comments (thank you for the input btw!). Here's what I found: I tried using the "home axis" command directly from the printer interface on the LCD, and it looks like that froze the entire machine. It didnt move any of the motors and ...

Hello All, I did my best to search the forums to see if anyone else has run into this, but I came up short. Here's the issue: a print had finished up while I was out, and when I got home I got everything set up for the next one. After everything got back up to temperature I clicked print and ...