Search found 6 matches
- Sat Mar 10, 2018 2:56 am
- Forum: Troubleshooting
- Topic: Need Help Adjusting Soft Limits on Rostock V2
- Replies: 4
- Views: 3522
Re: Need Help Adjusting Soft Limits on Rostock V2
Line 196, in firmware from https://github.com/seemecnc/Firmware has a minimum of -100. The same line in regular Repetier 0.92.2 is zero. Latest Repetier (1.0.1) is line 296.
- Fri Mar 09, 2018 12:11 pm
- Forum: Troubleshooting
- Topic: Printer won't home... Please help!
- Replies: 2
- Views: 2573
Re: Printer won't home... Please help!
When you try the calibration it should home first, but it can't since the Y carriage is going the wrong way, so it should be the same problem in both cases. That looks live a v2 upgraded with HE280, ball joint arms and injection molded carriages. I just performed the same upgrade and had the same be...
- Tue Mar 06, 2018 6:47 pm
- Forum: Artemis
- Topic: Lubricating linear rails?
- Replies: 13
- Views: 10243
Re: Lubricating linear rails?
I never even thought about lubrication until I was recently trying to fix a problem that was caused by the bearing sleeves. One of the many things I tried was adding lubriplate ( http://www.amazon.com/gp/product/B000FJ07W2 ) to the towers. It didn't seem to make any improvement. I now have a strange...
- Fri Mar 02, 2018 3:47 pm
- Forum: Troubleshooting
- Topic: Need Help Adjusting Soft Limits on Rostock V2
- Replies: 4
- Views: 3522
Re: Need Help Adjusting Soft Limits on Rostock V2
In the Seemecnc fork of Repetier, a line was changed in Printer.cpp to allow negative Z, from this: allowed &= (z >= 0) && (z <= zLength + 0.05 + ENDSTOP_Z_BACK_ON_HOME); to this: allowed &= (z >= -100) && (z <= zLength + 0.05 + ENDSTOP_Z_BACK_ON_HOME); It might be better to ...
- Tue Aug 25, 2015 9:22 pm
- Forum: MatterControl
- Topic: Different speed when part is duplicated
- Replies: 3
- Views: 3122
Re: Different speed when part is duplicated
That's it - thank you! I thought I thoroughly looked through the settings for anything that would be affected by the size of the print, but I apparently missed this: Filament > Cooling > Slow Down If Layer PrintTime Is Below: 40 seconds. I set that to zero seconds and printed a 1-up part, and it pri...
- Mon Aug 24, 2015 10:11 pm
- Forum: MatterControl
- Topic: Different speed when part is duplicated
- Replies: 3
- Views: 3122
Different speed when part is duplicated
I've been using the default ABS and STANDARD slicing profiles from the SeeMeCNC download page, which have been working well. After several prototype iterations for a part, I duplicated it to print five at a time. When I print five at once with the same settings, suddenly the printer is moving and ex...