Welcome to the SeeMeCNC Community

Rostock Max V2 I had a print get stuck to the glass and in trying to remove it, the glass shifted quite a bit. My next print wasn't level. I went through the calibration steps in sections 2.3 and 2.4 in the user guide. The X tower is contacting the glass. I have the screw turned all the way to the r...

Using 5 seconds dropped the print time to 15 minutes.

I think that's it. The Slow Down If Layer Print is Below was set to 40 seconds. I'm going to try it at 5. MatterControl is now giving me 29 minutes. Thanks for the help!

I have a Rostock Max V2. I'm running Standard Quality with default Speed settings. Infill 40, Top Solid Infill 30, Inside Perimeters 40, Outside Perimeter 35, Support Material 40, Bridges 60, Travel 300, First Layer Speed 12. I've tried increasing most of these values to 60 mm/s and had virtually no...

I've completed through steps 6.9 of the assembly instructions. My kit included the "new" idler bearing spacers for the "A" series instructions. Once I installed the tower supports in the base, the idler bearing sleeves can barely rotate using my fingers. The nuts are just hand-ti...