Welcome to the SeeMeCNC Community

The parts that im using for the test has been printed before and printed correctly before. I'm wondering about the skipping step correctly since this new cheapstake has most of a spring load and when I put the belt on might have put more force on the belt. I'm wondering about the screw for the end ...

hmm I already recalibrate Z height as in the first post with a tight grip on the paper about or less then 0.003" to 0.004" roughtly about 0.07mm if that is my understanding on how thick most stock paper are. The layer height I was printing before was 0.2mm (before with good print) and now I'm trying ...

Hi all, I'm having an issue with the first layer being too far away from bed. What happen was that I had my loose wire on my PEEK fan wire shorted (wire tape came off), blow the fuse and replaced the fuse. The printer started up like normal now after the replaced fused. Calibrated the towers again ...