Welcome to the SeeMeCNC Community

So its safe to crimp the 4 pin connector to the 20" AWG cable to the Rambo. Its just not safe to `tin` the leads on the 20" AWG cable to the Rambo? I'm refering to the Warning on Page 211 of the Assembly Guide. So then there's a difference between solder tin and the AWG cable? both are goi...

I am adding an E3D V6 hot end, which uses a heat cartridge. The cabling from the heat cartridge will not reach up and then back down to the Rambo Controller. I would like to solder it to a 4-pin connector (from motors) and then connect that to a cable connected to the Rambo controller. This will wou...

Where could that be? Where the arms join to the carriages? Whatever the problem is, I think it only occurs once and then its all over, so sure could be caused only at a certain position. I have tried slowing down and speeding up the printer and the problem still happens (just in more or less time, m...

When printing a wide object, after a few layers, the platform moves down impacting the bed a few times, then moving vertically. It continues the print, but for all the next layers, the platform moves vertically +/- about 10-15mm (for the same layer) as well as moving horizontally. 1. this is the fir...