Search found 6 matches
- Tue Jul 05, 2016 4:59 pm
- Forum: Troubleshooting
- Topic: First layer not sticking problem
- Replies: 7
- Views: 4759
Re: First layer not sticking problem
Hi all, Thank you so much for your suggestions, I switch my surface material to the blue painter tape, it's working pretty well, Another key change is that I use an piano wire to clean up the nozzle, somebody must leave some burned PLA causing a jam in nozzle. Once the material could be extruded smo...
- Tue Jul 05, 2016 11:27 am
- Forum: Troubleshooting
- Topic: First layer not sticking problem
- Replies: 7
- Views: 4759
Re: First layer not sticking problem
some settings i'm using, i've tried different first layer height, it's not working
- Tue Jul 05, 2016 11:23 am
- Forum: Troubleshooting
- Topic: First layer not sticking problem
- Replies: 7
- Views: 4759
Re: First layer not sticking problem
these are two picture of my first layer print
- Tue Jul 05, 2016 10:59 am
- Forum: Troubleshooting
- Topic: First layer not sticking problem
- Replies: 7
- Views: 4759
Re: First layer not sticking problem
update: I fix the leveling problem by adjusting screws, but PLA material is still not sticking to gaffer tape, i'll upload some image later, please, guys, really need help here.
- Tue Jun 28, 2016 3:15 pm
- Forum: ORION
- Topic: First layer not sticking problem
- Replies: 1
- Views: 3859
First layer not sticking problem
Hi everyone, I'm using an ORION printer, a problem came up that the first layer is always not attaching to the bed. I'm using PLA, extruder 200/bed 60. One layer of white gaffer tape on glass heated bed. I've tried a lot of different Z height, from too far to too close to bed. They were all not work...
- Tue Jun 28, 2016 3:14 pm
- Forum: Troubleshooting
- Topic: First layer not sticking problem
- Replies: 7
- Views: 4759
First layer not sticking problem
Hi everyone, I'm using an ORION printer, a problem came up that the first layer is always not attaching to the bed. I'm using PLA, extruder 200/bed 60. One layer of white gaffer tape on glass heated bed. I've tried a lot of different Z height, from too far to too close to bed. They were all not work...