Welcome to the SeeMeCNC Community

Please see previous post. Am I way off base? We've also noticed that increasing the layer height has an averse effect on final print weight. Printing at a default speed of 2400-3000 mm/min with 80% underspeed (Simplify3D), should it be an issue to have layer heights around .3mm on a .7mm nozzle? We ...

Okay, so I am within 5% of the projected weight (sliced by Simplify3D) when I print this "cube". I printed once solid, once at 0% infill, and once at 35% with 3 perimeters, tops, and bottoms. Each trial was about 5% below which is definitely an improvement. This relative success is for a flow rate ...

Does anyone weigh their prints after completion to assess under/over extrusion? We have 3 rostock Max machines (two V2 and one V3) and while many of the final products pass the eye test some of the prints are coming out 40% under the weight that is being predicted with our slicer (Simplify3D). Even ...