Welcome to the SeeMeCNC Community

Hey Trash88, great job! I got it all wired up and it seems to be working but too sensitive. I keep getting this error while probing: Error: Z probe already triggered at start of probing move I tried changing the Z_PROBE_SENSITIVITY to 8 and it is still not working. Any other suggestions? UPDATE: 8 ...

SeemeCNC newbee here. I'm not the best at understanding G-codes (Barley enough to be dangerous) but have a question about this topic. Is there a way that I can get this to calibrate prior to every print. I have a RoboR1 that does the bed leveling check before every print? I just built my V3 Max and ...

Ok disregard last post. I ordered a Teensy. Once i have this connected will it work with the duet wifi firmware or is there anything special that needs to be set to make it work? For example since you used the E0 for the probe and the Z-probe for init. This is great BTW! Very much looking forward to ...

Hey do you know if an arduino nano will work? I know the clock is much slower but i have a whole drawer full of them.
Never used Teensy, is the code similar to arduino?

Ill order a Teensy if i have to but would be good to use what i have

Thanks guys

Great work!

I have installed the master firmware from 120916 and it is not working for me: M115 gets this: Send: N11 M115*22 Recv: ok 11 Recv: FIRMWARE_NAME:Repetier_0.92.2 FIRMWARE_DATE:20161209 MACHINE_TYPE:Rostock MAX v3 Recv: Printed filament:0.00m Printing time:0 days 0 hours 0 min But i get this in the ...

Is there something special that matter controller does or can I use octoprint instead?

Hey Guys,

I modified the EZR struder to include an optical filament sensor.
http://www.thingiverse.com/thing:1913357

It prints but i haven't hooked it up yet. Welcome any feedback.