Search found 6 matches
- Sun Mar 17, 2019 9:54 am
- Forum: Rostock MAX Official Docs
- Topic: Rostock Max V4 Docs
- Replies: 1
- Views: 3682
Rostock Max V4 Docs
Any chance of an offline PDF or something? Seemecnc.dozuki.com is completely down and has been for the past hour.
- Mon Oct 16, 2017 8:22 pm
- Forum: RostockMAX v3
- Topic: Brand New Rostock v3 build stringing/oozing
- Replies: 7
- Views: 6322
Re: Brand New Rostock v3 build stringing/oozing
So apparently Matter Control was a huge culprit in this. I tried using Cura to slice and the piece came out 1000 times better. All rights the blobs are all gone and the only thing left now are really super fine strings. I'm going to try tweaking some retraction settings in Cura but it's a massive di...
- Mon Oct 16, 2017 7:46 am
- Forum: RostockMAX v3
- Topic: Brand New Rostock v3 build stringing/oozing
- Replies: 7
- Views: 6322
Re: Brand New Rostock v3 build stringing/oozing
I was wondering if that could be the case. My inexperience is going to show now, but how exactly would I go about testing this? The thermocouple, is this like a device to check the temperature? I'm assuming something like this ? Also, how would I go about calibrating the thermister settings after ge...
- Sun Oct 15, 2017 10:36 am
- Forum: RostockMAX v3
- Topic: Brand New Rostock v3 build stringing/oozing
- Replies: 7
- Views: 6322
Re: Brand New Rostock v3 build stringing/oozing
I just must be doing something wrong. I can't seem to get this dialed in. Everything else looks spectacular. Amazing first layer, amazing perimeters. It just strings and oozes. I calibrated the Hot End to be exact. It was a tiny hair off. I ran the Delta Calibration wizard to the point where my resu...
- Sat Oct 14, 2017 8:14 am
- Forum: RostockMAX v3
- Topic: Brand New Rostock v3 build stringing/oozing
- Replies: 7
- Views: 6322
Brand New Rostock v3 build stringing/oozing
So I finally finished building my v3 yesterday and it went super smoothly. No problems at all. I plugged it in and the calibration cube printed OK...tweaked it with the delta calibration wizard and it printed perfectly. Then I tried to print a benchy and that's where I ran into trouble. As you can s...
- Mon Sep 25, 2017 11:17 am
- Forum: New Member introduction
- Topic: Hello SeeMeCNC Community
- Replies: 2
- Views: 3872
Hello SeeMeCNC Community
I'm an accountant from NJ with some 3D Printing experience. I used to have a Prusa I3 (from way back in early 2013) but it died on me about a year ago so I've been itching to get back into it. I've been saving for a while and finally took the plunge and ordered a Rostock Max v3. This will be my firs...