Welcome to the SeeMeCNC Community

Dale, you might on to something here! Notice how the first tap is large, then the next less, then it is fine. Could it be the center of the bed flexing downwards with the first hit and then the system compensates for the location a bit each time? I wonder what would happen if we slow down the ...

I have heard that owning a 3D printer is a love-hate affair. I'm currently in the latter state. I have disassembled and reassembled the hot bed snowflake, onyx, and glass -- ensuring everything is level and flat and secure. I have adjusted belt tension, ensured towers are perpendicular to the bed ...

I'm beginning to wonder if it is some type of electrical interference to the accelerometer caused by the power supply (which happens to be biased towards the Z and Y towers and furthest from teh x tower)...

Ok, I've cleared my EEPROM and reloaded firmware with V3 printer "5" selected and inverted the Y-axis in firmware and it all seems to work -- EXCEPT i'm still getting the same plane issue when using the probe to calibrate. It is high at the Z tower (too high to adhere to the print surface) and too ...

Hello, I recently also upgraded my V2 to the new hot end. I cleared the EEPROM and then uploaded the new firmware with "5" selected for V3. Mistake! My Y-axis was inverted . I then cleared the EEPROM and uploaded firmware with "2" selected for V2. This time it seems to work fine, but when I run the ...