Welcome to the SeeMeCNC Community

Thanks for the link Mac, helped a lot in getting to the problem. Finally got back to the stepper problem today. Below are the new settings I changed in config.h. So far the stepper is still not responding and I am not sure if there are other config.h settings that are interfering - though it seems ...

The stepper is a Wantai 2.5A(U).

Yes, I recently updated the firmware to the latest that SeeMe had on their site. Then I ran the printer for a calibration block which took about 1.5h. Then started to see that the stepper was not behaving, then it pooped out entirely. With the current change is it possible that the motor is now dead ...

I have an issue with the stepper on my Rostock V2. I recently changed to a E3D V6 hot end and after re configuring the printer eeprom and recalibration I was able to print a reasonable calibration block. After the first block I was ready to run another part however (waiting a day or so) when I came ...