Welcome to the SeeMeCNC Community

Ok. Thanks to you both. I folded end over end and it was sucessful. Thanks again!

I had one hell of a time seating the 28 gauge wires in the connector. For now I'll run it like this. Thanks for the advice!

SOLVED! It turns out i had a bad I2C connection at the hotend. I tinned the wires and reinstalled and now everything is great. Thanks again for the assistance.

Clint

Hi Alan,

It is fully assembled including the glass plate. Ill try to 'home' the printer tonight. I struggled for 3 hours last night, finally quit cause beer was gone.

I just completed my build of a Rostock Max V3. Everything seemed to go very well. Last night I fired it up and loaded the firmware and Matterhacker control software. I then performed a G29 calibration and it crashed down hard to the X axis. The belts are adjusted properly. I double checked the wirin...

PM sent.