Search found 5 matches

by marvinsanremo
Mon May 22, 2017 5:59 pm
Forum: Rostock MAX v2
Topic: FSR setup guide
Replies: 10
Views: 8266

Re: FSR setup guide

Well after a lot of reading and considering, I decided to pull the trigger on the Duet Wifi + Digikey parts to make the nice connections. I also ordered the new version of the EZstruder. I currently have a 450w atx PS. Since I will be running a new board, hot end, etc, will that be enough power? If ...
by marvinsanremo
Fri Apr 21, 2017 2:17 pm
Forum: Rostock MAX v2
Topic: FSR setup guide
Replies: 10
Views: 8266

Re: FSR setup guide

Thank you for the clarifications, it helps me not be too frustrated now. I was under the assumption that calibration has gotten better since that thread, hence the reason I was looking for newer information. So at this point, I have a newer rep firmware configured, and it seems to be working finally...
by marvinsanremo
Sun Apr 16, 2017 8:38 pm
Forum: Rostock MAX v2
Topic: FSR setup guide
Replies: 10
Views: 8266

Re: FSR setup guide

Thank you for the link. I have read that thread many times, but it isn't really complete for RAMBO users. The final conclusion at the time was that it was working, but not great, and the duet was a better option. It was from two years ago, so I assumed that probing in rep has gotten much better. Tha...
by marvinsanremo
Sun Apr 16, 2017 11:22 am
Forum: Rostock MAX v2
Topic: FSR setup guide
Replies: 10
Views: 8266

FSR setup guide

I have searched far and wide for a good write-up on getting the FSR setup to work. Unfortunately, there isn't one guide to follow, just pieces garnered from different posts. I get the basic idea of the FSR, and it seems like it would be simple to use. But at this point, I either don't have the corre...
by marvinsanremo
Thu Apr 13, 2017 7:57 pm
Forum: New Member introduction
Topic: Hello from Santa Barbara, CA
Replies: 1
Views: 2486

Hello from Santa Barbara, CA

I just wanted to say hello to the forum. I recently bought a lightly used Rostock Max V2. It was completely stock with almost no hours on it. I went to work right away on upgrading some important parts (although I did learn how to calibrate it while everything was stock). So far I have installed the...

Go to advanced search