Welcome to the SeeMeCNC Community

I noticed the flashing and figured that was happening so I turned off hotend fan and hot end and bed. Still same behavior though.

Thx Gene. I followed the link In the upgrade wiki. Guess it was old. The reason I was struggling with it was that although auti calibrate works fine, when i run mesh comp, it fals with”z probe akready triggered” after the 1st point is probed. I reduced the radius to 120 to see if it would help but i...

But where is the syntax. Its not in the wiki?

M270 is used in several files to define the new probe. This command does not shiw up in the duet wiki. What’s the story?