Those four wires that the directions tell you to bundle up in the wire management are the Z probe wires for the Artemis machines made without FSR (or is it FRS). I just put mine together and was getting a Z probe error until I hooked up those four wires to the probe port on the Duet board.
K
Search found 3 matches
- Thu Aug 09, 2018 8:56 pm
- Forum: Artemis
- Topic: Enable strain gauge Z probe?
- Replies: 22
- Views: 14814
- Thu Aug 09, 2018 8:31 pm
- Forum: Artemis
- Topic: Newb’s first problem
- Replies: 0
- Views: 2323
Newb’s first problem
Well I just posted my intro up in the new member introduction section and hinted at a small issue. After sorting out my hotend fan issue I printed my second benchy and it went much better than the first print, but still not without its problems. [img]https://www.limpidity.org/wp-content/uploads/2018...
- Thu Aug 09, 2018 8:15 pm
- Forum: New Member introduction
- Topic: Hello from Maryland
- Replies: 0
- Views: 2756
Hello from Maryland
Well here goes my Newb post. Hi My name is Infringer and I have a patience problem that I need to work on, I decided that 3D printing would help my need for Instant gratification. After many years of wanting a 3D printer and playing with my Dad’s a few times I decided that it was time to take the pl...