Welcome to the SeeMeCNC Community

Wow, that probably should've been my first guess. I feel like that was probably a waste of your guys' time. I tried a new power supply, and it's back to it's old self. I guess it's time to printing.

Thanks everyone for your help!

If I had to throw a guess at it, based on a total shut down (kills the PS until power cycle) I would guess you have a short that is only occurring after thermal expansion. No movement right? There is indeed no movement and everything shuts off including the power supply. However, I've finally found ...

Hello, I'm new to the forum and just recently finished building my Rostock MAX. I have a question about it shutting off while it attempts to heat up before a print. I was able to print my first calibration cube, which turned out surprisingly well, but after that I haven't been able to keep the ...