Search found 32 matches
- Tue Apr 22, 2014 10:55 am
- Forum: Troubleshooting
- Topic: Rostock V2 assembly issue
- Replies: 6
- Views: 4765
Re: Rostock V2 assembly issue
Better angle
- Tue Apr 22, 2014 10:53 am
- Forum: Troubleshooting
- Topic: Rostock V2 assembly issue
- Replies: 6
- Views: 4765
Re: Rostock V2 assembly issue
It has two slots and not hole for stop screw.
- Tue Apr 22, 2014 12:12 am
- Forum: Troubleshooting
- Topic: Rostock V2 assembly issue
- Replies: 6
- Views: 4765
Re: Rostock V2 assembly issue
These screws perform the same function as the ones previously installed in the lower tower mounts. This helps guarantee that the top section will be at the correct height on all three towers. Note that your kit will ship with a part that looks very much like the one to the right. This was a very ...
- Mon Apr 21, 2014 11:29 pm
- Forum: Rostock MAX Official Docs
- Topic: [NEW! 12Feb14] Rostock MAX Assembly Manual
- Replies: 174
- Views: 309817
Re: [NEW! 12Feb14] Rostock MAX Assembly Manual
Right now I'm very much at a loss in the assembly of the V2.
Section 7 is talking about installing a stop screw for the T-channel towers, however the vertical supports have been changed in the latest revision of the kit and there is no place for the stop screw.
What do I do now???
Section 7 is talking about installing a stop screw for the T-channel towers, however the vertical supports have been changed in the latest revision of the kit and there is no place for the stop screw.
What do I do now???
- Mon Apr 21, 2014 11:10 pm
- Forum: Troubleshooting
- Topic: Rostock V2 assembly issue
- Replies: 6
- Views: 4765
Rostock V2 assembly issue
Right now I'm very much at a loss in the assembly of the V2. Section 7in the assembly manual is talking about installing a stop screw for the T-channels on the top section, however the vertical supports have been changed in the latest revision of the kit and there is no place for the stop screw ...
- Mon Apr 21, 2014 11:02 pm
- Forum: New Member introduction
- Topic: A Noob needing directions to success!
- Replies: 14
- Views: 11128
Re: A Noob needing directions to success!
Thank you both for the speedy reply. I can hardly wait to get to the site you listed Tinyhead. Right now I'm very much at a loss in the assembly of the V2. Section 7 is talking about installing a stop screw the T-channels, however the vertical supports have been changed in the latest revision of the ...
- Sun Apr 13, 2014 4:14 pm
- Forum: New Member introduction
- Topic: A Noob needing directions to success!
- Replies: 14
- Views: 11128
A Noob needing directions to success!
Hello all! I've been teaching basic electronics, facsimile repair and copiers for Canon, Mita, Minolta and others but have just gotten bit by the Arduino and now 3D printing bug. Being a serious tinkerer and explorer that thinks beyond the material in front of me and out of the box, I drooled when I ...