Welcome to the SeeMeCNC Community

Um, no.

g.

That's not testing the output of the power supply.

Did you make any changes to the printer prior to the problem manifesting itself? (uploading firmware, etc.)

g.

I would check the output of the power supply.

g.

The fuse locations can be found here: https://docs.duet3d.com/Duet3D_hardware/Duet_2_family/Duet_2_WiFi_Ethernet_Hardware_Overview look at the "features" section - the fuses are shown with a red highlight and they're on the right side of the board. I would also check to make sure that the ...

If the spring was causing problems, it means that the balls needed to be lubricated. I would lubricate all the ball joints with a little white lithium grease and then replace that spring. When the probing is too fast, you'll get a warning message in the web interface about the probe results being in...

Run the delta calibration twice (g32) and then print. How does it look? (don't use bed mapping)

g.

I've got a similar issue with my v4. Are you seeing that after a normal delta cal, or after you've done a height map? How does it print without the height map?

I've pinged Part Daddy on this, so hopefully he'll stick his nose in soon.

g.

Then you need to make the same adjustment for the extruder drives.

g.

Twingert, assuming you're using the WiFi interface, look here: https://github.com/seemecnc/RostockMAX-v4/tree/master/SD%20Wifi All the configuration settings for your machine should be in there - the items that will affect your homing direction are in the M569 commands. Do you have S0 set for the fi...

\o/

Looks like some great deals! I'm sorry to see you're closing!

I fixed the url in your post - it ended "..caFor".

g.

Great!

g.

They're kind of hard to brick. It's more likely that the either the wrong firmware was uploaded, or the right firmware with the wrong configuration was uploaded. You can grab the firmware from here: https://github.com/seemecnc/Firmware/tree/master/Repetier%20Firmware Go through the Configuration.h f...

The plugin may need to be updated for the latest Octoprint. I don't have the time to do it, sorry.

g.

I have no idea, sorry. You might want to ask Part Daddy directly.

g.

It absolutely is.

g.

It hasn't been discussed here. It's basically a dick move on Flashforge's part.

g.

What happens when you flip the glass over? Same result?

g.

The delrin balls were the first version. The aluminum didn't come until much later. There's no reason I know of to prefer the Delrin version, but you might want to email them about it.

You might want to let them know about the URL issue.

g.

Delrin vs Aluminum for the ball assemblies depends on your use. If you're going for maximum print speed, you want maximum stiffness in the motion system, which means going to the metal ball assemblies and carbon fiber arms. The Meanwell LRS-350-12 is a good choice. Single rail power supplies are typ...

\o/

I would check for belt wear and to see if the belt drive gears are still tight. Barring that, you might want to email support.

g.

I'm running retracts at 25mm/sec and the retract length is 6.5mm. I'm printing at 60mm/sec with an infill speed of 100mm/sec. This is for my BOSSDelta 300 though. (it uses an SE300 hot end, so basically anything that uses the SE300 can use those speeds) I'm wondering if your retract speed and length...

I contacted HQ and asked if they could build me an upgrade kit for my shopping cart. They said there was no direct path from v2 to v5, so in short, no. My plan: 1. order a duet 3. My understanding is that they run the same, but the 3 is the future and can handle more current if needed: https://www....