Welcome to the SeeMeCNC Community

Purchased this printer from a seller locally and did a complete teardown/rebuild to make sure everything is perfect. Just finished rebuilding last week and have printed a few things with great results. Looking to sell as I want to start exploring resin printing. I will break the printer down into as few pieces as I can so you have little assembly. All wiring has been done with connectors(even endstops) so reassembly should be simple. You will need to complete the setup again as you probably figured. Shipping will be via UPS with tracking. More than likely this will either be shipped in 2 boxes. I'm pretty new here but have great feedback on rcgroups.com, helifreak.com, rc.runryder.com under user name jprochnow. On ebay my user name is eightball_golf. Any questions feel free to ask. Pictures will be uploaded tonight.

DECIDED TO KEEP.

Pictures attached. The gear print was one of my first prints. Since then there has been adjustments to improve on filling. The frog was printed at a .2 layer height and then vapor smoothed, it was in vapor for 45 seconds. Turned out real nice.

OP wanted to keep his RoMax v2. Thread closed. If he wants to open it at any time, let an admin know.