Hey All,
I thought many of you might be interested to know that Warner Berry (BerryBot Maker) is now selling some of the more desirable parts from his setup.
You can buy:
1) Magnetic Arms
2) End Effectors
3) Steppers
4) Ball Magnets and Machined End Caps
5) and so on......
Check him out at http://www.shopspt.com" onclick="window.open(this.href);return false;
I am not affiliated with him in any way, I am just a subscriber to his Youtube channel and this new site address was on his last video. Not having access to the machining equipment myself, I sure appreciate it when people like Warner who do make products I can use.
Enjoy..........
Parts From Warner Berry (BerryBot Maker) Now Available
-
- Printmaster!
- Posts: 94
- Joined: Mon Jun 03, 2013 12:25 pm
- Eaglezsoar
- ULTIMATE 3D JEDI
- Posts: 7185
- Joined: Sun Apr 01, 2012 5:26 pm
Re: Parts From Warner Berry (BerryBot Maker) Now Available
Thanks for the link, I can see that these are quality parts.
Do you know if the BerryStruder handles 1.75mm filament?
Do you know if the BerryStruder handles 1.75mm filament?
-
- Prints-a-lot
- Posts: 30
- Joined: Sun Jun 07, 2015 9:00 pm
Re: Parts From Warner Berry (BerryBot Maker) Now Available
Would using the magnetic joints, the rods, and effector platform they sell cause the need to change the firmware for a Rostock Max V2? or would you just recalibrate and thats it?
- Jimustanguitar
- ULTIMATE 3D JEDI
- Posts: 2631
- Joined: Sun Mar 31, 2013 1:35 am
- Location: Notre Dame area
- Contact:
Re: Parts From Warner Berry (BerryBot Maker) Now Available
If the geometry doesn't change (i.e. the length of the arms and the carriage/effector offsets) you'd just need to recalibrate to dial in the finer adjustments like horizontal radius and you'd be up and printing in no time.
They're not bolt-on parts, though. It would be a custom job.
They're not bolt-on parts, though. It would be a custom job.