Will the Delrin covers on Misumi 2020

A place for the physical connections
Post Reply
mkx
Plasticator
Posts: 17
Joined: Mon Aug 18, 2014 5:13 pm

Will the Delrin covers on Misumi 2020

Post by mkx »

Will the delrin covers over the 608zz work with misumi 2020?
User avatar
Nylocke
ULTIMATE 3D JEDI
Posts: 1421
Joined: Sun Jun 23, 2013 1:43 pm
Location: Iowa

Re: Will the Delrin covers on Misumi 2020

Post by Nylocke »

As long as its 1" it should be fine. 30mm may be pushing it, but it could work. 20mm is probably too small, though I am speculating. They were designed for 1" T-slotted aluminum extrusions.
Eric
Printmaster!
Posts: 726
Joined: Sat Aug 18, 2012 4:09 am
Location: Chula Vista, CA

Re: Will the Delrin covers on Misumi 2020

Post by Eric »

I think the width of the slot opening is more important than the total width of the extrusion for this question.

Misumi 2020 has a 6mm wide slot. So does 2525, which uses the same size slot. 3030 moves up to an 8mm slot.

The slot width on 1 inch extrusion is 0.255", a bit larger than 6mm. 1.5 inch extrusion uses 0.320" slots, which is quite close to 8mm (0.315").


0.236" = 6mm
0.255" = 6.477mm

Measure your bearing cover. What do you think?

Isn't it fun comparing metric and inch standards?
mkx
Plasticator
Posts: 17
Joined: Mon Aug 18, 2014 5:13 pm

Re: Will the Delrin covers on Misumi 2020

Post by mkx »

Thanks guys. I haven't purchased the bearings yet, but will do now.
Post Reply

Return to “Nuts and Bolts”