Page 1 of 1
24v steppers
Posted: Thu Jun 14, 2012 3:01 pm
by jbinion
I have a bunch of these 24v steppers Mitsumi M49sp-2k from printers thyat I have torn apart. Are they useful or will the high volts make them basically useless for cnc/printers?
Thanks
Re: 24v steppers
Posted: Wed Jul 18, 2012 5:00 pm
by tom10122
I think they should work as long as they get enough power
Re: 24v steppers
Posted: Wed Jul 18, 2012 9:36 pm
by michaellatif
Well. . . they are ok, they are 7.5 degrees per step. That will make precision and quality prints less possible. The biggest problem I think you will have is mounting them to the H-1.
Re: 24v steppers
Posted: Fri Jul 20, 2012 9:07 am
by jbinion
Thanks, I think I'll save them for something else. We were looking into using 123d Catch so it might work ok for a turntable.