Simplify3D Settings

The new for 2016 RostockMAX v3!
Post Reply
PhantamaroK
Plasticator
Posts: 10
Joined: Fri Oct 28, 2016 9:22 pm

Simplify3D Settings

Post by PhantamaroK »

Would any kind soul be willing to share their Simplify3D settings? At this point I'm throwing darts at the wall with regard to retraction, etc. and would love to use someone else's common settings as a base.

geneb
ULTIMATE 3D JEDI
Posts: 5161
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Simplify3D Settings

Post by geneb »

Try the files in the attached zip. There are profiles for a number of materials & machines.
jwcproductions FFF.zip
(56.09 KiB) Downloaded 3 times
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects

PhantamaroK
Plasticator
Posts: 10
Joined: Fri Oct 28, 2016 9:22 pm

Re: Simplify3D Settings

Post by PhantamaroK »

geneb wrote:
Fri Nov 20, 2020 8:36 am
Try the files in the attached zip. There are profiles for a number of materials & machines.
jwcproductions FFF.zip
g.
Thank you so much for these files! They're very valuable.

Quick question: are the settings in the Rostock MAX v3 profile the same for the v3.2 upgrade?

geneb
ULTIMATE 3D JEDI
Posts: 5161
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Simplify3D Settings

Post by geneb »

No, the v3 uses an 8 bit RAMBo controller and the v3.2 uses the 32 bit Duet controller. It makes them VASTLY different machines because of that.

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects

Post Reply

Return to “RostockMAX v3”