I got a RM32 stock with carbon fiber arms already installed and they updated Duet before shipping. I read on the carbon fiber arms page: "These arms are slightly longer than arms for the RostockMAX series, so the maximum printable height will be shorter" and from the RM32 page: "Carbon fiber arms decrease the height, however increase the printable diameter."
What build volume would I put into slicers with the carbon fiber arms on the RM32? I'm not sure if it is tiny or significant change?
Build volume with carbon arms
Re: Build volume with carbon arms
Home the machine and subtract 1mm from the Z height shown in the Duet display. That's a reasonable figure to use for max printing height.
g.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Re: Build volume with carbon arms
You're welcome!
g.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects