Simplify3D Settings
-
- Plasticator
- Posts: 10
- Joined: Fri Oct 28, 2016 9:22 pm
Simplify3D Settings
Would any kind soul be willing to share their Simplify3D settings? At this point I'm throwing darts at the wall with regard to retraction, etc. and would love to use someone else's common settings as a base.
Re: Simplify3D Settings
Try the files in the attached zip. There are profiles for a number of materials & machines.
g.Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
-
- Plasticator
- Posts: 10
- Joined: Fri Oct 28, 2016 9:22 pm
Re: Simplify3D Settings
Thank you so much for these files! They're very valuable.
Quick question: are the settings in the Rostock MAX v3 profile the same for the v3.2 upgrade?
Re: Simplify3D Settings
No, the v3 uses an 8 bit RAMBo controller and the v3.2 uses the 32 bit Duet controller. It makes them VASTLY different machines because of that.
g.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects