The Artemis arrives in NJ

[magicmarc]

Thanks for the install status, as i'm also expecting the artemis i recently ordered. id built the h2 delta last year, and am looking forward to the new artemis, heated bed, faster, wireless, etc.. so thanks for the build report! im here in nyc, so maybe NJartemis could advise as well when mine arrives! (as im not so good with testing using the multimeter , i have one but need to know how to use properly...)

[AlanZ]

Marc, let me know if you have any questions.

[AlanZ]

And a 510mm rocket print.

https://www.youtube.com/watch?v=vwbRbQYCNjI

[adarcher]

Wait, can you recap what had to be replaced to fix the flutter? I seem to get flutter-like symptoms on one or more axes when I do small movements.

Plus, my z motor alternates directions, but that’s another issue.

[dc42]

...
Plus, my z motor alternates directions, but that’s another issue.

Sounds like only one phase of the Z motor is getting energised.

[AlanZ]

Adarcher,

The fix for my fluttering was to replace the 4 wires that extended the extruder's wires to the plug that goes to the board,

I don't know why this worked, as the original solder joints looked good, and when I plugged my new stepper into the old extension wires, it too fluttered.

Now that I replaced the wires and connected them to the original stepper, all is well.

[adarcher]

...
Plus, my z motor alternates directions, but that’s another issue.

Sounds like only one phase of the Z motor is getting energised.

I don’t remember exactly, but that could be me not pushing the pins in all the way right? I’ll check those again, I was attempting to be careful about that.