FSR-equipped Artemis calibration note.

The one, the only, the Atremis. Forum for the monster metal machine from SeeMeCNC
Post Reply
geneb
ULTIMATE 3D JEDI
Posts: 5362
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

FSR-equipped Artemis calibration note.

Post by geneb »

If you've got an FSR-equipped Artemis 300 and you're having calibration problems, check to make sure your bed clip is clearing the sheet metal chassis as shown in the image below.
clamp clearance detail.jpg
The reason for this is that if the clip is in contact with the Artemis chassis, nominal nozzle pressure won't be enough to trigger the FSR at that location, causing either failed probes or excessive nozzle pressure.

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
adarcher
Printmaster!
Posts: 138
Joined: Thu Nov 05, 2015 2:46 am

Re: FSR-equipped Artemis calibration note.

Post by adarcher »

Thanks for pointing that out. I rushed to check if that was my issue. Sadly it wasn't, but I'll keep it in mind.
Post Reply

Return to “Artemis”