Do these Duet cover panel and access 'port/window' models live anywhere on the github archives as .stl/other?
I was going to mod the V3 LCD panel / fit the Duet access port to that if so.
My current Duet mount places SD access about 3.2cm from the side panel.
Are you V3.2/4 operators using a mount that moves the Duet closer to the edge?
Any .stl's for those?
If not I can just mod the .stl/other file to be more inset.
This forum is for discussions specific to the Duet-equipped RostockMAX v3.2 3D printer.
1 post • Page 1 of 1