Field Service Bulletin Ground Wire October 2020

This is where you can discuss the RostockMAX v4!
Post Reply
User avatar
PartDaddy
Printmaster!
Posts: 367
Joined: Fri Mar 23, 2012 4:03 pm

Field Service Bulletin Ground Wire October 2020

Post by PartDaddy »

We have issued a Field Service Bulletin (FSB) for the RostockMAX v4 3D printer.

Please take a moment to download the official FSB document in this post and perform the correction.

Summary of this FSB:
The printer DC Negative output of the power supply needs to be connected to the AC
Ground (GND). This guide will provide instructions on how to perform the installation of
the grounding wire for each specific model. This guide also provides the proper method
of testing to ensure the service has been completed properly.

SeeMeCNC Field Service Bulletin Grounding Wire FSB Oct 14 2020.pdf
FSB-2020-Oct-14
(1.96 MiB) Downloaded 85 times
~PartDaddy
SeeMeCNC Owner & Founder
Blackpoint Engineering is SeeMeCNC
Since 1996

DDXdesign
Printmaster!
Posts: 40
Joined: Mon Apr 01, 2019 10:56 am

Re: Field Service Bulletin Ground Wire October 2020

Post by DDXdesign »

Any chance you could just send out kits? buying just one connector or a few inches of wire is pretty difficult sometimes... And how much is a VOM going to run?

Post Reply

Return to “RostockMAX v4”