Page 1 of 1
KISSlicer
Posted: Wed Apr 29, 2015 10:18 am
by Ziggey
I downloaded Kisslicer and have been trying to familiarize myself with it. I have wanted a few videos read the setup ect. I'm rocking the Rostock Max V2. I supported the Diamond 3 in one printer on kickstarter and I would like to have Kisslicer homed in and ready to print by the time it gets here( A FEW MONTHS!!!
)) So on that note My Kisslicer didn't start on the bed of the machine. What settings did I mess up???
Thank you,
Ziggey
Re: KISSlicer
Posted: Wed Apr 29, 2015 4:29 pm
by Earthbound
Ziggey wrote:I downloaded Kisslicer and have been trying to familiarize myself with it. I have wanted a few videos read the setup ect. I'm rocking the Rostock Max V2. I supported the Diamond 3 in one printer on kickstarter and I would like to have Kisslicer homed in and ready to print by the time it gets here( A FEW MONTHS!!!
)) So on that note My Kisslicer didn't start on the bed of the machine. What settings did I mess up???
Thank you,
Ziggey
Suggest starting from mhackney's very good initial configuration files in the KISSlicer sub-forum.
Re: KISSlicer
Posted: Wed Apr 29, 2015 11:33 pm
by mhackney
Moved to the Kiss topic...
Your issue is vague. It sounds more like you have not set Z=0 correctly rather than a slicer issue.