Greetings

Introduce yourself to the community!
Post Reply
Jarvis
Noob
Posts: 1
Joined: Fri Jun 05, 2020 3:32 pm

Greetings

Post by Jarvis »

I just picked up a new Rostock Max V2. The previous owner bought a kit right after the V2 was introduced and lost interest in 3D printing about the time he nearly finished assembling it. I just needed to finish wiring the extruder stepper and install the firmware. I think. Maybe. We'll see what happens next when I try to calibrate it later.

Wish me luck.

User avatar
PartDaddy
Printmaster!
Posts: 362
Joined: Fri Mar 23, 2012 4:03 pm

Re: Greetings

Post by PartDaddy »

Hi Jarvis, Original instructions can be found here:
https://www.seemecnc.com/pages/downloads
~PartDaddy
SeeMeCNC Owner & Founder
Blackpoint Engineering is SeeMeCNC
Since 1996

Post Reply

Return to “New Member introduction”