Hello From Everett, WA

Introduce yourself to the community!
Post Reply
Michail1
Plasticator
Posts: 11
Joined: Sat Sep 14, 2019 11:21 am

Hello From Everett, WA

Post by Michail1 »

It took many years to get me to purchase a 3D printer as I didn't know if I would use it enough to justify the cost.

Friend convinced me just over a year ago to buy a SeeMeCNC. So, I bought the V3.2 Kit. It went nearly flawlessly.
One one bad power supply which was replaced quickly in warranty.

Not using it enough? Ha! I've used the shit out of it. In fact, I needed to print faster. So, I bought a V4. Not so flawlessly of a build as I had with the V3.2, but it was expected. It's nearly perfect after a few adjustments, reversing the plugs, correctly aligning some pins, and replacing the head fans. I'm happy to have 2 printers pumping out the filament.
geneb
ULTIMATE 3D JEDI
Posts: 5362
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Hello From Everett, WA

Post by geneb »

\o/
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Post Reply

Return to “New Member introduction”