I just picked up a new Rostock Max V2. The previous owner bought a kit right after the V2 was introduced and lost interest in 3D printing about the time he nearly finished assembling it. I just needed to finish wiring the extruder stepper and install the firmware. I think. Maybe. We'll see what happens next when I try to calibrate it later.
Wish me luck.
Greetings
Re: Greetings
Hi Jarvis, Original instructions can be found here:
https://www.seemecnc.com/pages/downloads
https://www.seemecnc.com/pages/downloads
~PartDaddy
SeeMeCNC Owner & Founder
Blackpoint Engineering is SeeMeCNC
Since 1996
SeeMeCNC Owner & Founder
Blackpoint Engineering is SeeMeCNC
Since 1996