Hello,
I bought a RAMPS 1.4 to remplace the original board of the H-1.
After a first connection test, the motors aren't working (they vibe a little). I think it's the connection between the RAMPS and the motors.
I use Printrun as software and Sprinter as firmware
So, how to connect the motors to the RAMPS ? (red wire to 1A port, green to 1B,... for example)
Thanks
How to connect the RAMPS to the H-1 motors
- michaellatif
- Printmaster!
- Posts: 357
- Joined: Mon Mar 26, 2012 1:34 pm
- Location: RTP, NC
Re: How to connect the RAMPS to the H-1 motors
Wiring diagram (use wire color coding to hook up motors).
http://reprap.org/wiki/RAMPS_1.4#Wiring
http://reprap.org/wiki/RAMPS_1.4#Wiring
Mike Latif
H-1 #3
H-1 #3