Here is the Gen6 wiki page on reprap.
I have one of these boards and only played around with it. My experience was positive though. I would like to build another H-1 configured with the Gen6. It is a single board that controls all 4 steppers and the hot end with thermistor feedback. It does not provide control for a heated bed like the RAMPS solutions do.
Cheers,
Michael
RepRap Official Gen6 Board Site
RepRap Official Gen6 Board Site
Sublime Layers - my blog on Musings and Experiments in 3D Printing Technology and Art
Start Here:
A Strategy for Successful (and Great) Prints
Strategies for Resolving Print Artifacts
The Eclectic Angler
Re: RepRap Official Gen6 Board Site
I does run Marlin and I have had some decent experiences with Gen6.
Re: RepRap Official Gen6 Board Site
Found a Utube video that helps understanding the firmware for a new person
http://youtu.be/7BE4xT7cqis
http://youtu.be/7BE4xT7cqis