OK - so I got the new mhackney snowflake replacement for FSRs, and I have it installed on my v2. I'm looking for a way to secure my heat spreader and glass build plate.
Any have a favorite glass build plate clamp they care to share?
Chuckle - now I think about holddowns.
-
- Printmaster!
- Posts: 71
- Joined: Sun Feb 14, 2016 10:26 pm
Chuckle - now I think about holddowns.
Dionysus480 & Sons
Rostock MAX v2 - "M2D2"
"Do or do not, there is no try." Yoda
Rostock MAX v2 - "M2D2"
"Do or do not, there is no try." Yoda
Re: Chuckle - now I think about holddowns.
Binder clips.
g.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
-
- Printmaster!
- Posts: 71
- Joined: Sun Feb 14, 2016 10:26 pm
Re: Chuckle - now I think about holddowns.
Thanks! But of course the problem is that there is no clearance for binder clips. I'll need to design something cool like the v3 has. Of course I need to hold the plate on while I print. Maybe some tape as a temporary holder. Bet my trigger point changes for the fsr between tape and an actual firm hold down clamp.
Dionysus480 & Sons
Rostock MAX v2 - "M2D2"
"Do or do not, there is no try." Yoda
Rostock MAX v2 - "M2D2"
"Do or do not, there is no try." Yoda
Re: Chuckle - now I think about holddowns.
Ah, I wasn't aware of that. Even the small ones won't fit?
g.
g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Re: Chuckle - now I think about holddowns.
Swiss Clips take up much less room than binder clips.