Bondtech Extruder Problems
Posted: Sun Oct 01, 2017 2:49 am
I finally managed to get back to working on my rostock v2 and the extruder is acting weird.
Here is how the filament starts out.
[img]http://i.imgur.com/dziq7sHundefined.jpg[/img]
Here is how it ends up after a few minutes and it stops feeding.
[img]http://i.imgur.com/tx0ygGpundefined.jpg[/img]
Any Ideas? I believe it has something to do with the amount of pressure building up in the hot end.
It extrudes fine to start with and as it goes it extrudes less and less until it just chews up the filament and stops extruding
Here is my config.g file
Edit to clarify and add config file
Here is how the filament starts out.
[img]http://i.imgur.com/dziq7sHundefined.jpg[/img]
Here is how it ends up after a few minutes and it stops feeding.
[img]http://i.imgur.com/tx0ygGpundefined.jpg[/img]
Any Ideas? I believe it has something to do with the amount of pressure building up in the hot end.
It extrudes fine to start with and as it goes it extrudes less and less until it just chews up the filament and stops extruding
Here is my config.g file
Edit to clarify and add config file