Artemis extruder falling after print.

Having a problem? Post it here and someone will be along shortly to help
Post Reply
androiddrew
Noob
Posts: 1
Joined: Fri May 29, 2020 11:26 am

Artemis extruder falling after print.

Post by androiddrew »

So after a few months the head of my extruder has started to fall after printing. What sucks is since that since the nozzle is still hot when it falls on the part it imbeds itself into as it cools. What have people done to address this problem? Is it a belt tensioning issue?
Attachments
IMG_3598.jpg
IMG_3598.jpg (1.99 MiB) Viewed 33 times
geneb
ULTIMATE 3D JEDI
Posts: 5226
Joined: Mon Oct 15, 2012 12:47 pm
Location: Graham, WA
Contact:

Re: Artemis extruder falling after print.

Post by geneb »

Remove the M84 from the end gcode in Cura (or whatever slicer you're using). M84 turns off the motors and will allow the effector to fall under its own weight.

g.
Delta Power!
Defeat the Cartesian Agenda!
http://www.f15sim.com - 80-0007, The only one of its kind.
http://geneb.simpits.org - Technical and Simulator Projects
Post Reply

Return to “Troubleshooting”