Assembly of the Prometheus V2
Posted: Wed Dec 07, 2016 11:15 am
Hi guys,
I just received my promotheus hotend, and i have a few questions.
After reading the instructions and installing the hotend on my Rostock.... i cloged it just after 10 minutes...
For information, I did the modification on the firmeware and a PID autotune. I use an EDGE filament from E3d at 240°. i don't know really whats happen, i check a video on youtube about the prometheus (https://www.youtube.com/watch?v=J_TJTh83tlg) and i have noticed a hex nut on the cold zone after the Heater Block but not on the official instruction, why the hex nut? Furthermost i have a hole for one M3x3mm Set Screw right next to the heater cartridge but nothing on the official instructions , maybe I lost a bit of heat wiht no screw in ? so need a screw ?
Is someone have some ideas..
Here a picture:
I just received my promotheus hotend, and i have a few questions.
After reading the instructions and installing the hotend on my Rostock.... i cloged it just after 10 minutes...
For information, I did the modification on the firmeware and a PID autotune. I use an EDGE filament from E3d at 240°. i don't know really whats happen, i check a video on youtube about the prometheus (https://www.youtube.com/watch?v=J_TJTh83tlg) and i have noticed a hex nut on the cold zone after the Heater Block but not on the official instruction, why the hex nut? Furthermost i have a hole for one M3x3mm Set Screw right next to the heater cartridge but nothing on the official instructions , maybe I lost a bit of heat wiht no screw in ? so need a screw ?
Is someone have some ideas..
Here a picture: