So My son and I had to take a break away from his printer- Max V2
We have upgraded it to a Duet Wifi. Well, I was a dumb... and while trying to upgrade to a new firmware I deleted everything on the SD card.
I've been searching for a while now. I remember someone had posted a really good guide that included all the config files.
Can someone please point me to that guide again.
Thanks
It's been a long time, need a little direction
Re: It's been a long time, need a little direction
Ok slowly finding my way around again. Found the RepRapFirmware Configuration Tool.
Can anyone link me to the entries used for a Max V2?
Still searching here, no luck so far. Sorry it's been almost 10 months and just cant find any of the old info I had and I feel like I'm starting over.
Thanks
Can anyone link me to the entries used for a Max V2?
Still searching here, no luck so far. Sorry it's been almost 10 months and just cant find any of the old info I had and I feel like I'm starting over.
Thanks
-
- ULTIMATE 3D JEDI
- Posts: 1561
- Joined: Wed Sep 23, 2015 2:55 pm
Re: It's been a long time, need a little direction
Sorry about the delay. perhaps http://forum.seemecnc.com/viewtopic.php ... duet+setup ?
Otherwise, I have a config for my modded V2 (E3D w/ PT100 sensors, Bondtech extruder, FSRs, etc), that I could potentially clean up for you.
Otherwise, I have a config for my modded V2 (E3D w/ PT100 sensors, Bondtech extruder, FSRs, etc), that I could potentially clean up for you.
Machines:
Rostock Max V2, Duet .8.5, PT100 enabled E3D V6 and volcano, Raymond style enclosure
Automation Technology 60W laser cutter/engraver
1m X-carve router
Sic Transit Gloria Mundi
01-10011-11111100001
Rostock Max V2, Duet .8.5, PT100 enabled E3D V6 and volcano, Raymond style enclosure
Automation Technology 60W laser cutter/engraver
1m X-carve router
Sic Transit Gloria Mundi
01-10011-11111100001
Re: It's been a long time, need a little direction
Thanks. Mr Hackney helped me out.