It's been a long time, need a little direction

Having a problem? Post it here and someone will be along shortly to help
Post Reply
TwoTone
Printmaster!
Posts: 144
Joined: Tue Jun 14, 2016 6:36 pm

It's been a long time, need a little direction

Post by TwoTone »

So My son and I had to take a break away from his printer- Max V2

We have upgraded it to a Duet Wifi. Well, I was a dumb... and while trying to upgrade to a new firmware I deleted everything on the SD card.

I've been searching for a while now. I remember someone had posted a really good guide that included all the config files.

Can someone please point me to that guide again.

Thanks
TwoTone
Printmaster!
Posts: 144
Joined: Tue Jun 14, 2016 6:36 pm

Re: It's been a long time, need a little direction

Post by TwoTone »

Ok slowly finding my way around again. Found the RepRapFirmware Configuration Tool.

Can anyone link me to the entries used for a Max V2?

Still searching here, no luck so far. Sorry it's been almost 10 months and just cant find any of the old info I had and I feel like I'm starting over.

Thanks
Xenocrates
ULTIMATE 3D JEDI
Posts: 1561
Joined: Wed Sep 23, 2015 2:55 pm

Re: It's been a long time, need a little direction

Post by Xenocrates »

Sorry about the delay. perhaps http://forum.seemecnc.com/viewtopic.php ... duet+setup ?

Otherwise, I have a config for my modded V2 (E3D w/ PT100 sensors, Bondtech extruder, FSRs, etc), that I could potentially clean up for you.
Machines:
Rostock Max V2, Duet .8.5, PT100 enabled E3D V6 and volcano, Raymond style enclosure
Automation Technology 60W laser cutter/engraver
1m X-carve router

Sic Transit Gloria Mundi
01-10011-11111100001
TwoTone
Printmaster!
Posts: 144
Joined: Tue Jun 14, 2016 6:36 pm

Re: It's been a long time, need a little direction

Post by TwoTone »

Thanks. Mr Hackney helped me out.
Post Reply

Return to “Troubleshooting”